Getting Started; Installing The Configtool Ip Utility; Discovering Your Device On The Network; Assigning A New Ip Address To Your Device - Honeywell H2W2PRV3 Software Configuration Manual

2 Getting Started

This chapter contains the following sections:
• Installing the ConfigTool IP Utility, page 7
• Discovering Your Device on the Network, page 7
• Assigning a New IP Address to Your Device, page 7
• Upgrading Your Device's Firmware, page 9
• Opening a Web Client, page 10

Installing the ConfigTool IP Utility

Before you can start using your camera, you must install the ConfigTool IP utility on your PC.
1. Insert the software CD that came with your camera into your PC's disk drive.
2. Open the Honeywell ConfigTool folder, and then double-click Honeywell ConfigTool.exe.
3. On the ConfigTool welcome screen, click Next.
4. Read the User License Agreement. If you agree, select I agree.
5. If you want, you can change the installation directory (by default, ConfigTool will be installed in
C:\Program Files). To proceed with the installation, click Install.
6. If the installation is successful, the message "Installation is complete!" appears. Click Enjoy Now to
open ConfigTool.

Discovering Your Device on the Network

Use ConfigTool to discover your IP device(s) on the network. To discover your device(s), open ConfigTool.
All of the connected IP devices on the network are listed. To refresh the list, click Refresh.

Assigning a New IP Address to Your Device

The current IP address of your device appears in the IP column of the ConfigTool main interface. If you
want, you can assign a new static IP address to the device.
1. From the list of devices in ConfigTool, click the device that you want to assign a new IP address to.
Click Login, type the login user name and password for the device (the default user name is admin
2.
and the default password is 1234), and then click OK.
Getting Started
7