Table of Contents
Advertisement
2. Insert the USB device that contains the new BIOS image ("Super.ROM") into a USB
port. Be sure the file is saved in the very top (root) folder.
3. Set the JBR1 switch on the motherboard to recovery mode and power on the system. If
the screen appears as below, press <DEL> to continue.
4. After locating the new BIOS binary image, the system will enter the BIOS recovery menu
as shown below.
Note: At this point, you may decide if you want to start with BIOS Recovery. If you decide to
proceed with BIOS Recovery, follow the procedures below.
5. When the screen shown above displays, use the arrow keys to select the item "Proceed
with flash update" and press the <Enter> key. You will see the BIOS recovery progress
as shown in the screen below.
Note: Do not interrupt the BIOS flashing until it has completed.
6. After the process has completed, press any key to reboot the system.
Appendix D: UEFI BIOS Recovery/Boot Block
105
Advertisement
Table of Contents
