Table of Contents
Advertisement
Operation
If the drive/lift level sensor interlock shuts off the platform
raise and drive functions, lower the platform and drive to
a level surface.
Fold Down Guardrails
The platform guardrails may be folded down to pass the
machine under low height obstructions.
Danger
The potential for an accident increases when the fold
down rails are lowered. Death or serious injury can
result in such accidents. Do not elevate the platform
with the fold down rails lowered. Use extreme care
when moving the aerial platform while the fold down
rails are lowered.
Use the following procedure to lower the platform guard-
rails.
1. Remove all materials from the platform floor and
retract the extension deck.
2. Remove the upper control panel from the side guard-
rail and place it on the floor of the platform.
3. Remove the pin from the hinged top rail on the exten-
sion deck. Fold the hinged rail in as far as it will go.
4. Lift the left hand extension deck rail up and fold it
down inwards.
5. Remove the pin from the hinged top rail on the main
deck. Fold the hinged rail in as far as it will go.
6. Lift the left hand main deck rail up and fold it in-
wards.
7. Lift the right hand extension deck rail up and fold it
down inwards.
8. Lift the right hand main deck rail up and fold it in-
wards.
9. Reverse this procedure to reposition the rails.
14
Swing-Out Trays
Batteries and hydraulic components are enclosed in
swing-out trays on each side of the chassis.
•
The battery tray on the left side of the chassis con-
tains the battery disconnect, batteries and the battery
charger.
•
The hydraulic tray on the right side of the chassis
contains the lower controls, the hydraulic reservoir,
and the hydraulic fluid filter.
Danger
The aerial platform can tip over if it becomes unstable.
Death or serious injury can result from a tip-over
accident. Do not open the trays when the platform
is elevated.
To open the swing-out tray, push down on the latch and
swing the tray open.
Emergency Lowering
Use the following procedure to operate the emergency
lowering system.
Warning
The potential for an accident increases when safety
devices do not function properly. Death or serious
injury can result from such accidents. Immediately
push the emergency stop button inward to disable the
control system before using the emergency lowering
system in the event of an emergency.
1. Immediately push the emergency stop button inward
to disable the control system in the event of an emer-
gency.
2. Retract the platform extension deck if possible.
3. Make sure there is nothing in the way to obstruct the
platform when it lowers.
•
S1930E and S1932E machines – push downward
on the lever to lower the platform.
•
S2632E machines – pull outward on the handle to
lower the platform.
4. Make certain the lever/handle is fully released and
the emergency lowering valve is fully closed before
operating the aerial platform.
S1930E/S1932E/S2632E – 1360417
Advertisement
Table of Contents
