Stick Starting Methods - Everlast POWERPRO 256SI Operator's Manual

Section 3
Basic theory and function
STICK OPERATION
STARTING METHODS
Tapping Method Scratch/Match Method
1. Turn on the power switch on the rear of the unit. Allow unit to cycle through its start up program.
2. Select the Stick mode with the HF/Cut/Stick selector switch.
3. Make sure electrode holder is connected to the positive terminal and the work clamp is connected to the
negative connector. Make sure the connectors are twisted until light resistance is met.
4. Select the amps desired. Use the electrode diameter selection chart in this manual to determine the ap-
proximate range of amps suitable for the rod size selected. Consult the welding electrode manufacturer's rec-
ommendation for proper amperage range. Each manufacturer has specific recommendations for its elec-
trodes. Usually these can be found on the packaging or on the respective manufacturer's website.
5. Use the arc force control to select the desired arc characteristics, creating the desired arc characteristic and
automatic amp response needed to maintain the arc when voltage falls below the threshold. 6011 Cellulose
electrodes will require more arc force control than other rods, but each brand and size will weld a little differ-
ently. The arc force control setting will vary from person to person as well, with different rod angles, posi-
tions, and arc lengths all factoring into the arc force control performance. Use the Start amps control knob to
adjust hot start intensity if sticking or arc starting difficulty is encountered.
6. Strike the arc with either the tapping method or the match strike method. Beginners usually find that the
match strike method yields best results. Professionals tend to gravitate toward the tapping method because
of its placement accuracy which helps prevent arc striking outside of the weld zone.
7. Terminate the arc by flipping the tip of the electrode up quickly with a quick flick of the wrist. Alternately
pull directly back on the rod with a brisk smooth motion.
IMPORTANT: Do not weld in the TIG mode with the stick electrode holder still attached.
30