Inside The Vehicle Test - Launch X-431 PADII User Manual

LAUNCH

7.4.2 Inside the vehicle test

Battery test and charging system & actuation system test can be done
in this mode.
1. Battery test
Enter battery test main menu, and select a desired test environment
as shown in Fig. 7-4.
Notes: The sequences of inside the vehicle and outside the vehicle
test are almost the same, but under inside the vehicle condition, all
loads in vehicles must be powered off for getting an exact test value.
1. Firstly, the system detects whether floating electricity exists or not
before testing. If yes, turn on the headlamp to remove it. Otherwise,
the system starts test program directly.
2. Tap [Inside the vehicle], the system starts detecting floating
electricity automatically. If floating electricity is detected, it will
prompt you to turn on the headlamp.
3. Follow the on-screen instructions to turn on headlamp, the system
starts removing floating electricity.
4. Once the floating electricity is removed, a prompt message box "The
Fig. 7-4
floating electricity has been removed, please turn off the headlamp
to continue the testing" will appear on the screen.
5. Follow the on-screen instructions to turn off the headlamp and
tap [OK], the system will continue the testing. Tap
testing standard selection screen. See Fig. 7-5.
6. Select a testing standard except for JIS and tap
similar to Fig. 7-6 will appear. Users can adjust capacity size by
tapping on < or > or by dragging the slider on the bar.
X-431 PADII User's Manual
, it will enter
Fig. 7-5
, a screen
Fig. 7-6
33