Mitsubishi Electric MR-J4 Instruction Manual page 379

11. OPTIONS AND PERIPHERAL EQUIPMENT
(c) Cable clamp fitting AERSBAN-_SET
Generally, the grounding of the shielded wire may only be connected to the connector's SD terminal.
However, the effect can be increased by directly connecting the cable to an grounding plate as
shown below.
Install the grounding plate near the servo amplifier for the encoder cable. Peel part of the cable
sheath to expose the external conductor, and press that part against the grounding plate with the
cable clamp. If the cable is thin, clamp several cables in a bunch.
The cable clamp comes as a set with the grounding plate.
Dimensions
Cable
Cable clamp
(A, B)
External conductor
Clamp section diagram
2-φ5 hole
installation hole
(Note) M4 screw
Note. Screw hole for grounding. Connect it to the grounding plate of the cabinet.
Model
AERSBAN-DSET
AERSBAN-ESET
Earth plate
[Unit: mm]
Earth plate
17.5
6 22
35
A B C Accessory fittings
100 86 30 Clamp A: 2pcs.
70 56 Clamp B: 1pc.
11 - 84
Strip the cable sheath of
the clamped area.
Clamp section diagram
L or less
Clamp fitting
A
B
[Unit: mm]
cutter
cable
[Unit: mm]
10
L
70
45