Replacing The Back Cover; Procedure - Dell Embedded Box PC5000 Service Manual

Replacing the back cover

WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in Before working inside your Embedded Box
Embedded Box PC, follow the steps in
Box PC. For more safety best practices, see the Regulatory Compliance
home page at www.dell.com/regulatory_compliance.

Procedure

1 Replace the hard-drive
2 Insert the tabs on back cover at an angle into the slots on the chassis.
3 Open the back cover.
4 Route the SATA-power and SATA-data cables through the routing guides.
5 Connect the SATA-power and SATA-data cable to the hard drive or solid-state
drive assembly.
NOTE: Connect the cables to the second drive if installed.
6 Close the back cover.
7 Align the screw holes on the back cover with the screw holes on the chassis.
8 Replace screws that secure the back cover to the chassis.
cage.
PC. After working inside your
After working inside your Embedded
23