Table of Contents
Advertisement
2 / INSTALLING YOUR APPLIANCE
•
Recycling
— Remove the back-flow valve (fig. 1).
— Using the two screws (fig. 2), attach the plastic
smoke deflector against the wall, flush with the
ceiling. Be careful to centre the deflector in
relation to the vertical line drawn on the wall
(fig. 2).
— Slide one end of the flue over the deflector and
the other end over the motor outlet (fig. 3).
— Prepare your ventilation shaft, taking care to
face the vents upward so that they are visible
(B/fig. 3).
— Attach the upper portion of the ventilation
shaft (C/fig. 3) on the metal smoke deflector
(A/fig. 3) using the two screws (F/fig. 3).
— Adjust the length of the telescoping ventilation
shaft by bringing down the lower part and fitting
it into the top of the hood.
Smoke deflector
A
B
Vents
C
Telescoping ventilation shaft
Flue
D
Motor bracket
E
Ventilation shaft holding screw
F
Tip
For optimal use of your appliance, we
recommend that you connect the hood to a
150-mm diameter flue (not delivered with the
appliance). Minimise the number of angles
and bends and the lengths of the flue. In the
event that the hood will be operated using
outdoor evacuation, you should ensure a
sufficient inflow of fresh air to avoid a
pressure deficiency in the room.
A
D
E
53
EN
fig. 1
fig. 2
B
F
C
fig. 3
Advertisement
Table of Contents
