Using The Evacuation Mode; Using The Recycling Mode - DeDietrich DHD556ZE1 Manual To Installation

99636281_ML_A.qxp 25/07/2005
2 / INSTALLING YOUR APPLIANCE
- The appliance must be unplugged during installation or when any repairs or maintenance work
is being performed.
- Ensure that the network voltage corresponds to the voltage noted on the identification plate
located inside the hood.
- If the electrical installation at your residence requires any changes in order to hook up your
Appliance, call upon a professional electrician.
- If the hood is being used in evacuation mode, do not connect the appliance to a combustion
gas exhaust duct (boiler, chimney, etc.) or to a CMV (controlled mechanical ventilation) system.
- Under no circumstances should the exhaust duct empty into the attic.
- Install the hood at a safe distance of at least 70 cm from an electric, gas or combined cooking
hob.
• •

USING THE EVACUATION MODE

If you possess an outlet to the exterior
(fig. 1)
Your hood can be connected to this outlet
using a flue (minimum diameter Ø mm that is
enamelled, in aluminium, flexible or made of
inflammable material). If your flue is less than
125 mm in diameter, y y o o u u m m u u s s t t u u s s e e t t h h e e r r e e c c y y - -
c c l l i i n n g g m m o o d d e e . .
• •

USING THE RECYCLING MODE

If you do not possess an outlet to the exterior
(fig. 2)
All of our appliances can be used in recycling
mode.
In this case, you should add an active carbon
filter which will keep in odours.
(See Chapter 4: Changing the carbon filter.)
14:12 Page 51
51
EN
125
150
fig. 1
125
150
fig. 2