Installing Your Appliance; Using The Evacuation Mode; Using The Recycling Mode - DeDietrich Cooker hood Manual To Installation

2 / INSTALLING YOUR APPLIANCE

- The appliance must be unplugged during installation or when any repairs or maintenance work is
being performed.
- Ensure that the network voltage corresponds to the voltage noted on the identification plate located
inside the hood.
- If the electrical installation at your residence requires any changes in order to hook up your
Appliance, call upon a professional electrician.
- If the hood is being used in evacuation mode, do not connect the appliance to a combustion gas
exhaust duct (boiler, chimney, etc.) or to a CMV (controlled mechanical ventilation) system.
- Under no circumstances should the exhaust duct empty into the attic.
- Install the hood at safe distance of at least 35 cm from an cooking hob.
This appliance can be installed in either duction version or filtering version.
The appliance is supplied in the filtering version, the charcoal filter is installed (Ref.AH4063U1).
USING THE DUCTING MODE
•
If you posses an outlet to the exterior
(fig. 1)
Your hood can be connected to this outlet using a
flue (minimum Ø 125mm that is enamelled, in
aluminium, flexible or made of inflammable
material).
Your cooker hood is a filtering version. All you
need to do is to remove the charcoal filter first.
USING THE FILTERING MODE
•
If you do not posses an oulet to the exterior
(fig. 2)
All of our appliances can be used in recycling
mode.
The air and steam taken up by the unit are
purified with charcoal filter and returned to the
environment.
22
EN
fig. 1
fig. 2