Teleworker Vpn Client - Cisco RV345 Administration Manual

VPN
Step 8 Click Apply.

Teleworker VPN Client

The Teleworker VPN Client feature minimizes the configuration requirements at remote locations by allowing
the device to work as a Cisco VPN hardware client. When the Teleworker VPN Client starts the VPN
connection, the IPSec VPN server pushes the IPSec policies to the Teleworker VPN Client and creates the
corresponding tunnel.
To configure the Teleworker VPN Client, follow these steps:
Step 1 Click VPN > Teleworker VPN Client and configure the following:

Teleworker VPN Client

Auto Initiation Retry
Retry Interval
Retry Limit
Step 2 Click Apply.
Step 3 In the Teleworkers VPN Client table, click Add.
Step 4
Provide the following information in the Basic Settings section:
Name
Server (Remote Address)
Active Connection on
Startup
Check On or Off.Only one Teleworker VPN Client can have an active connection at
startup.If you enable one Teleworker VPN Client on startup, it will disable this option
on other client rules.
Check On or Off.
Enter the time in seconds (Range 120 to 1800).
Enter the maximum number of retries (Range 0 to 16).
Enter a name for the profile.
Enter the remote server's IP address.
To start connection on startup. At any point, only one profile can be in On state to start
negotiations at startup
Teleworker VPN Client
RV345/345P Administration Guide
89