Step 1; Rv345/345P Administration Guide - Cisco RV345 Administration Manual

WAN
WAN connections simultaneously. The VLAN interfaces of WAN can also be configured for load balance
or failover.
To configure the multi WAN settings, follow theses steps:

Step 1

Select WAN > Multi-WAN.
Step 2 In the Interface Setting Table, configure the following:
• Interface — WAN interface name to apply the load balance and failover configuration. Select and check the desired
interface (WAN1, WAN2, USB1, or USB2).
• Precedence (for Failover) — Enter the priority value for the interface to bring up another connection on another
interface.
• Weighted by Percentage or Weighted by Bandwidth (for Load-Balance) — Enter the weight percentage or
value for each connection. The interface routes traffic to the secondary connection if the primary connection's is
overloaded in an effort to balance the bandwidth load. To ensure full utilization of both connections, the ratio
between the connections' load balancing weights should reflect the ratio between the connections' bandwidths.
Step 3 Click Advanced Configuration and configure the following:
a) Enable Network Service Detection — Check to allow the device to detect network connectivity by pinging specified
devices and enter the settings as described here.
• Retry Count — Number of times to ping a device. The range is 1 to 10 and the default is 3.
• Retry Timeout — Number of seconds to wait between the pings. The range is 1 to 300 and the default is 5
seconds.
• Detect Destination — Select Default Gateway or Remote Host — If choosing the remote host, enter the host.
Step 4 Click Apply.
Step 5
Enable Policy Based Routing — Check to enable.
Step 6 Next, click Add or Edit and configure the following:
Priority
Source IP
Destination IP
Services
Outgoing Interface
Failover to backup WAN
Status
Enter a number for the priority.
Enter the source IP address.
Enter the destination IP address.
Select a service from the drop-down list. If a service is not listed, you can click Service
Management to add it.
Select the outgoing interface (WAN1, WAN2, USB1, or USB2) from the drop-down
list.
Select On or Off from the Failover to back up WAN drop-down list.
If you select Off, the traffic is dropped when the binding interface goes off line
Note
or down.
Select Enable or Disable to enable or disable the status of the policy.
Multi-WAN

RV345/345P Administration Guide

41