Multi-Wan - Cisco RV345 Administration Manual

Multi-WAN

Bridge Settings
Bridge to
IP Address
Netmask
Default Gateway
Static DNS 1 & 2
When the IPv6 connection uses SLAAC
In the SLAAC Settings section, enter the following information:
Static DNS 1 & 2
DHCP-PD (IPv6 only)
Step 9
Click Apply.
For Advanced
Step 10 Click the Advanced tab and configure the following:
MTU — Maximum
Transmission Unit
MAC Address Clone
Note When MAC Address Clone is enabled, the port mirroring does not
work.
Step 11 Click Apply.
Add any of these sub-interfaces to the Multi-WAN table to forward the default route traffic. Or it will only
Note
forward the connected route traffic based on the routing table.

Multi-WAN

WAN failover and load balancing features provide efficient utilization of multiple WAN interfaces. Based
on the configuration, this feature can be used to distribute traffic among the interfaces. The Multi-WAN feature
provides the outbound WAN traffic, and load balancing over multiple WAN interfaces (WAN & USB) based
on a numeric weight assignment. It also monitors each WAN connection using repeated ping tests and
automatically routes outbound traffic to another WAN interface if connectivity is lost. The specific outbound
traffic rules can also be configured because of 5-tuple of a connection. Outgoing network load-balancing is
performed on a per IP connection basis; it is not channel-bonding, where a single connection uses multiple
RV345/345P Administration Guide
40
VLAN1 is the default.
Enter the IP address.
Enter the netmask.
Enter the default gateway.
Enter the IP address of the primary and or secondary Static DNS in the fields.
Enter the IP address of the primary and or secondary Static DNS in the fields.
Check to enable and enter a prefix name.
Select Auto to set the size automatically. To set the MTU size manually, select Manual
and enter the MTU size. (The size in bytes of the largest protocol data unit that the
layer can pass.)
Check MAC Address Clone and enter the MAC address. Click Clone My PC's MAC
to use the MAC address of your computer as the clone MAC address for the device.
WAN