Ceiling Fan Assembly - Emerson VOLTA CF590BQ00 Owner's Manual

3. Ceiling Fan Assembly

3.10
Place the ceiling cover over the downrod (Figure 10).
Be sure that the ceiling cover and the coupling cover are
both oriented correctly (Figure 10).
3.11
Route the three 80" motor leads through the hanger ball
(Figure 11).
Reinstall the hanger ball on the downrod as follows:
Position the pin through the two holes in the downrod and
align the hanger ball so the pin is captured in the groove in
the top of the hanger ball (Figure 11).
Pull the hanger ball up tight against the pin and securely
tighten the Phillips head setscrew in the hanger ball
(Figure 11).
Loose setscrew could create fan wobble.
3.12
The fan comes with black, blue, and white leads that are
80-inches long.
Measure up approximately 6 to 9-inches above top of
hanger ball/4.5" downrod assembly (Figure 12).
Cut off excess leads and strip back insulation 1/2-inch from
end of leads.
(Continued)
Figure 10
4.5" DOWNROD
PHILLIPS HEAD
SETSCREW
Figure 11
1/2-INCH
6 TO 9
INCHES
Figure 12
8
DOWNROD
CEILING
COVER
PIN
HANGER BALL
BLUE WIRE
BLACK WIRE
WHITE WIRE
HANGER BALL
ETL Model No.: CF590