Electrical Requirements; Unpacking Instructions - Emerson VOLTA CF590BQ00 Owner's Manual

1. Unpacking Instructions

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
THIS FAN IS SUITABLE FOR WET LOCATIONS SUCH AS
Tools Needed for Assembly
One Phillips head screwdriver
One 1/4" blade screwdriver
Materials
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be a
3-conductor (2-wire with ground) of following size:
Installed Wire Length
Up to 50 ft.
50-100 ft.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and capable of
withstanding a load of at least 50 pounds.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable for
Fan Support of 22.7kg. (50 lbs.) or less", and use
screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not
acceptable for fan support and may need to be replac
ed. Consult a qualified electrician if in doubt.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
Install, Operate and Maintain Your Ceiling Fan
PORCHES, PATIOS, AND DECKS.
One stepladder
One wire stripper
Wire Size A.W.G.
14
12

2. Electrical Requirements

(Continued)
Your Emerson Ceiling Fan comes supplied with a
RCFP Receiver and Fan Remote Control. This system
allows you to regulate your ceiling fan speed and light
control.
This Emerson Ceiling Fan may be used with the
following accessory
SW605 Wall Control.
!
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 15). If you feel
you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
If your fan is to replace an existing ceiling light fixture, turn
electricity off at the main fuse box at this time and remove
the existing light fixture.
!
To avoid fire or shock, follow all wiring instructions
carefully.
Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
Please call Emerson
1-800-654-3545 if you have any questions about
installation and operation of this ceiling fan.
4
(purchased separately):
WARNING
WARNING
technical support
ETL Model No.: CF590
at