Removal Of Covers For Servicing; Removal Of Components For Service; Parts Replacement; Adjustments And Replacement Parts - Heat-N-Glo SL-550TRS-AUC Installation And Operation Instructions Manual

3.1 REMOVAL OF COVERS FOR
SERVICING
A. Control Compartment Grille
• Rotate the bottom grille down to access the gas
controls.
B. Dress Guard and Glass Door
• Lift the front dress guard up and out away from
the appliance side surrounds. Replace the dress
guard when servicing is complete.
• Release the glass clips around the glass door.
Carefully lift the glass up and out away from the
appliance (see Figure 34).
LATCHES
(BOTH TOP
AND BOTTOM)
GLASS
ASSEMBLY
Figure 34. Glass Assembly
3.2 REMOVAL OF COMPONENTS
FOR SERVICE
1. BURNER
• Remove the rear screws holding the log grate. Care-
fully lift up and remove the log set, log grate, and
metal base pan.
• Unscrew the brackets at both ends of the burner and
slide the burner towards the right away from the burner
orifice.
2. PILOT ASSEMBLY/IGNITION SYSTEM
• Remove the log set, log grate, and metal base pan.
• Disconnect the gas supply tube from the underside
of the pilot burner.
• Disconnect the electrode wire from the piezo ignitor
(found adjacent to the gas control valve).
• Disconnect the attachment nut from the underside
of the thermopile. The thermopile can then be sepa-
rated from the pilot bracket.
• Unscrew the pilot assembly bracket and remove.
NOTE: When removing the pilot assembly, care-
fully pull the electrode wire up through the grommeted
hole in the base pan.
3.3

PARTS REPLACEMENT

1. FAN/SWITCHES
• Disconnect the fan wires from the junction box wires
by pulling the male and female connectors apart and
slide the fan out the front of the lower controls com-
partment.
• Disconnect the wires from the fan speed control
switch, pull off the knob, and remove the nut holding
the speed control to the bracket.
• Disconnect the wires from the fan temperature sen-
sor switch and remove the nut holding the switch
bracket onto the side of the firebox.
2. GLASS PANEL
• To replace the glass door, place the bottom edge on
top of the bottom mounting brackets. Push glass
against unit and latch the two fasteners at the top of
the glass door and the two fasteners at the bottom
(see Figure 34).
3.4 ADJUSTMENTS AND
REPLACEMENT PARTS
Adjustments and replacement parts for this appliance
should only be done by a qualified service person. A
wiring diagram for the appliance is shown in SECTION
2.0 OPERATING INSTRUCTIONS. A replacement part
table is shown in SECTION 4.0 of this manual.
31