Removal Of Covers For Servicing; Removal Of Components For Service; Parts Replacement; Adjustments And Replacement Parts - Heat-N-Glo 6000TRS-AUB Assembly, Installation And Operation Instructions

3.1 REMOVAL OF COVERS FOR
SERVICING
A. Control Compartment Grille
• Lift the lower door up and out to access the gas
controls.
B. Trim door and Glass Door
• Lift the front trim door up and out away from the
appliance side surrounds. Replace the door when
servicing is complete.
• Noting carefully how the brackets fit on the glass,
release the two spring latches at the top and
two at the bottom of the glass door. Carefully lift
the glass up and out away from the appliance.
See Figure 34.
3.2 REMOVAL OF COMPONENTS
FOR SERVICE
1. BURNER
• Remove the front refractory bracket and carefully lift
up and remove the log set/log grate/refractory as-
sembly.
• Unscrew the brackets at both ends of the burner and
slide the burner away from the burner orifice.
2. PILOT ASSEMBLY/IGNITION SYSTEM
• Remove the log set/log grate/refractory assembly.
• Disconnect the gas supply tube from the underside
of the pilot burner.
GLASS DOOR
ASSEMBLY
FIGURE 34.
• Disconnect the electrode wire from the piezo ignitor
(found adjacent to the gas control valve).
• Disconnect the attachment nut from the underside
of the thermopile. The thermopile can then be sepa-
rated from the pilot bracket.
• Unscrew the pilot assembly bracket and remove.
NOTE: When removing the pilot assembly, carefully
pull the electrode wire up through the grommeted
hole in the base pan.

3.3 PARTS REPLACEMENT

1. FAN/SWITCHES
• Unplug the fan wires from the junction box wires by
pulling the male and female connectors apart and
slide the fan out the front of the lower controls com-
partment.
• Disconnect the wires from the fan speed control
switch, pull off the knob, and remove the nut holding
the speed control to the bracket.
• Disconnect the wires from the fan temperature sen-
sor switch and remove the nut holding the switch
bracket onto the bottom of the firebox.
2. GLASS PANEL
• To replace the glass door, place the bottom edge
into the lower holders, push glass against unit and
secure the two spring latches at the top and bot-
tom.
3.4 ADJUSTMENTS AND
REPLACEMENT PARTS
Adjustments and replacement parts for this appliance
should only be done by a qualified service person. A
wiring diagram for the appliance is shown in SECTION
2.0 OPERATING INSTRUCTIONS. A replacement part
table is shown in SECTION 4.0 of this manual.
26