Heat-N-Glo SL-550TRS-AUC Installation And Operation Instructions Manual page 2

INSTALLATION AND OPERATION INSTRUCTIONS
MODEL SL-550TRS-AUC
IS AUSTRALIAN GAS ASSOCIATION
APPROVED FOR NATURAL GAS OR
PROPANE AS A BALANCED FLUE
HEATER.
Refer to the appliance data plates for gas
consumptions and pressures.
Installation of this appliance should only be
carried out by an authorized person in ac-
cordance with the manufacturer's instruc-
tions. All relevant codes and regulations laid
down by the gas piping authorities, munici-
pal building regulations, electrical wiring
regulations and the requirements of the AGA
Gas Installation Code must be observed.
This appliance and its components are
tested and safe when installed in accor-
dance with this Installation Manual. Report
to your dealer any parts damaged in ship-
ment, specifically check glass condition. The
gas logs and flue system components are
in separate packages. Read all instructions
before starting installation and follow these
IMPORTANT: Read all instructions carefully before starting installation.
Failure to follow these installation instructions may result in a possible fire
hazard and will void the warranty. Save this Manual for future reference.
Copyright 2002
Heat-N-Glo, a division of Hearth Technologies Inc.
20802 Kensington Boulevard, Lakeville, MN 55044
Printed in U.S.A.
PLEASE READ THIS MANUAL BEFORE INSTALLING
AND USING THIS APPLIANCE.
instructions carefully during installation to
ensure maximum benefit and safety. Fail-
ure to follow them will void your warranty and
may present a fire hazard.
The Heat-N-Glo, a division of Hearth Tech-
nologies Inc. warranty will be voided by, and
Heat-N-Glo, a division of Hearth Technolo-
gies Inc. disclaims any responsibility for the
following actions:
• Installation of any damaged heater or
flue system component
• Modification of the heater or balanced
flue system installation other than as
instructed by Heat-N-Glo, a division of
Hearth Technologies Inc.
• Improper positioning of the gas logs or
the glass door
• Installation and/or use of any component
part not manufactured or approved by
Heat-N-Glo, division of Hearth Technolo-
gies Inc., not withstanding any inde-
pendent testing laboratory or other
party approval of such component part
or accessory.
2