Verifying Flexaddress Activation - Dell PowerEdge FX2 User Manual

Verifying FlexAddress activation

To view the FlexAddress feature activation status, run the following RACADM command:
racadm featurecard -s
Feature Name = FlexAddress
Date/time Activated = 05 Oct 2013 - 11:50:49
Feature installed from SD-card serial number = CN0H871T1374036T00MXA00
Feature Name = FlexAddressPlus
Date/time Activated = 05 Oct 2013 - 11:50:49
Feature installed from SD-card serial number = CN0H871T1374036T00MXA00
Feature Name = ExtendedStorage
Current Status = redundant, active
Date/time Activated = 05 Oct 2013 - 11:50:58
Feature installed from SD-card serial number = CN0H871T1374036T00MXA00
If there are no active features on the chassis, the command returns a message: racadm feature -s No features active on the chassis
racadm feature -s
No features active on the chassis
To view the SD card information:
$ racadm featurecard -s
Active CMC:
The feature card inserted is valid, serial number CN0H871T1374036T00MXA00
The feature card contains the following feature(s)
FlexAddress: bound
FlexAddressPlus: bound
ExtendedStorage: bound
Table 19. Status Messages Returned by the featurecard -s Command
Status Message
No feature card inserted.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: bound.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: bound to another chassis,
svctag=ABC1234, SD card SN = 1122334455.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: not bound.
Dell Feature Cards may contain more than one feature. Once any feature included on a Dell Feature Card has been activated on a
chassis, any other features that may be included on that Dell Feature Card cannot be activated on a different chassis. In this case,
the racadm feature -s command displays the following message for the affected features:
ERROR: One or more features on the SD card are active on another chassis
For more information on the feature and featurecard commands, see the Dell Chassis Management Controller for
PowerEdge FX2/FX2s RACADM Command Line Reference Guide.
Actions
Check CMC to verify that the SD card was properly inserted.
No action required.
Remove the SD card; locate and install the SD card for the
current chassis.
The feature card can be moved to another chassis or can be
reactivated on the current chassis. To reactivate on the current
chassis, enter racadm racreset until the CMC module with
the feature card installed becomes active.
117