Command Messages - Dell PowerEdge FX2 User Manual

Chassis management controller
Hide thumbs Also See for PowerEdge FX2:
Table of Contents

Advertisement

Command messages

The following table lists the RACADM commands and output for common FlexAddress situations.
Table 20. FlexAddress commands and output
Situation
SD card in the CMC module is bound to
another service tag.
SD card in the CMC module that is bound
to the same service tag.
SD card in the CMC module that is not
bound to any service tag.
FlexAddress feature not on the chassis for
any reason (No SD card inserted/ corrupt
SD card/ after feature deactivated /SD
card bound to a different chassis).
Guest user attempts to set FlexAddress
on slots/fabrics.
Deactivating FlexAddress feature with
chassis powered ON.
Guest user tries to deactivate the feature
on the chassis.
Changing the slot/fabric FlexAddress
settings while the server modules are
powered ON.
Changing the Flexaddress settings of slot
or fabric, when the CMC Enterprise
License is not installed.
Command
$racadm featurecard -s
$racadm featurecard -s
$racadm featurecard -s
$racadm setflexaddr [-f
<fabricName> <slotState>]
$racadm setflexaddr [-i
<slot#> <slotstate>]
$racadm setflexaddr [-f
<fabricName> <slotState>]
$racadm setflexaddr [-i
<slot#> <slotstate>]
$racadm feature -d -c
flexaddress
$racadm feature -d -c
flexaddress
$racadm setflexaddr -i 1 1
$racadm setflexaddr -
i<slotnum> <status>
$racadm setflexaddr -
f<FabricName> <status>
Output
The feature card inserted is
valid and contains the
following feature(s)
FlexAddress: bound to another
chassis, svctag = <Service
tag Number> SD card SN =
<Valid flex address serial
number>
The feature card inserted is
valid and contains the
following feature(s)
FlexAddress: bound
The feature card inserted is
valid and contains the
following feature(s)
FlexAddress:not bound
ERROR: Flexaddress feature is
not active on the chassis
ERROR: Insufficient user
privileges to perform
operation
ERROR: Unable to deactivate
the feature because the
chassis is powered ON
ERROR: Insufficient user
privileges to perform
operation
ERROR: Unable to perform the
set operation because it
affects a powered ON server
ERROR: SWC0242 : A required
license is missing or
expired. Obtain an
appropriate license and try
again, or contact your
service provider for
additional details.
NOTE: To resolve this issue, you
must have a FlexAddress
Enablement license.
119

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Poweredge fx2s

Table of Contents