Troubleshooting and recovery
This section explains how to perform tasks related to recovering and troubleshooting problems on the remote system using the
CMC web interface.
•
Viewing chassis information.
•
Viewing the event logs.
•
Gathering configuration information, error status, and error logs.
•
Using the diagnostic console.
•
Managing power on a remote system.
•
Managing Lifecycle Controller jobs on a remote system.
•
Reset components.
•
Troubleshooting Network Time Protocol (NTP) problems.
•
Troubleshooting network problems.
•
Troubleshooting alerting problems.
•
Resetting forgotten administrator password.
•
Saving and restoring Chassis configuration settings and certificates.
•
Viewing error codes and logs.
Gathering configuration information, chassis status, and logs using
RACDUMP
The racdump subcommand provides a single command to get comprehensive chassis status, configuration state information, and
the historic event logs.
The racdump subcommand displays the following information:
•
General system/RAC information
•
CMC information
•
Chassis information
•
Session information
•
Sensor information
•
Firmware build information
Supported interfaces
•
CLI RACADM
•
Remote RACADM
•
Telnet RACADM
racdump includes the following subsystems and aggregates the following RACADM commands. For more information about
racdump, see the Dell Chassis Management Controller for PowerEdge FX2/FX2s RACADM Command Line Reference Guide.
142
18