Genie TMZ-50/30 Service Manual page 89

June 2005
800-610-4101
ActionRental.com
REV B
2 Turn the key switch to ground control and pull
out the red Emergency Stop button to the on
position at both the ground and platform
controls. Pull out the red Emergency Stop
button to the on position at the drive controls (if
equipped).
Result: The power light should be on.
3 Push and hold the auto level button. Push and
hold the extend outrigger button.
Result: The outriggers will lower and adjust to
level the machine and raise the wheels slightly
off the ground. Use a digital level to confirm that
the machine is level.
4 Turn the key switch to the off position.
5 Locate the tilt level sensor behind the ground
control box.
a b
a
b
c
d
e
f
Part No. 65162
c d e f
hydraulic tank
battery charger (if equipped)
ground control box
voltage converter (if equipped)
motor controller (if equipped)
level sensor
If you are not installing a new level sensor,
proceed to step 11.
6 Tag and disconnect the wire harness from the
tilt level sensor.
7 Remove the fasteners securing the level sensor
to the machine. Remove the level sensor from
the machine.
8 Install the new level sensor onto the machine
with the "X" on the level sensor housing closest
to the ground control box, as shown in the
illustration below. Install and securely tighten
the level sensor retaining fasteners.
Tip-over hazard. The level sensor
must be installed with the "X" on
the level sensor base closest to
the ground control box. Failure to
install the level sensor as
instructed could result in the
machine tipping over causing
death or serious injury.
a
b
c
TMZ-50/30
Section 4 • Repair Procedures
GROUND CONTROLS
X
Y
hydraulic tank
ground control box
level sensor
a
b
c
4 - 35