Genie TMZ-50/30 Service Manual page 61

June 2005
800-610-4101
ActionRental.com
REV B
a
b
c
d
e
f
g
h
i
j
Part No. 65162
control box mount
gearbox top cover
rotate gear assembly
gearbox case
pinion
rotate handle shaft
rotate handle shaft cover
seal
platform pivot shaft
platform pivot
9 Thoroughly degrease and dry the gearbox case,
covers, all gear components and the platform
pivot shaft.
a
10 Install the gearbox case onto the platform pivot
shaft.
11 Install gear assembly onto the platform pivot
b
shaft in the reverse order of disassembly in
step 7.
12 Install the gear assembly retaining nut onto the
top of the shaft. Torque to specification.
c
Torque specification
Gear assembly retaining nut, dry
d
e
13 Thoroughly and heavily lubricate each tooth of
f
the gear using multipurpose grease. Rotate the
gearbox case as required.
g
When lubricating the gear, do not
apply any grease to the remainder
of the gear assembly components.
Grease on the balance of the gear
components may result in slippage
and poor rotator performance.
h
14 Install the rotate handle shaft, pinion and
associated components into the gearbox.
i
15 Thoroughly and heavily lubricate each tooth of
the pinion using multipurpose grease.
16 Install the rotate handle shaft cover. Install and
securely tighten the fasteners. Do not over
tighten.
j
17 Install the platform control box mount and
gearbox cover onto the top of the gearbox.
Install and securely tighten the fasteners. Do
not over tighten.
TMZ-50/30
Section 4 • Repair Procedures
PLATFORM COMPONENTS
180 ft-lbs ±5 ft-lbs
244 Nm ±7 Nm
4 - 7