Alarms And Indicators - Arjohuntleigh Auto Logic Instructions For Use Manual

Autofirm Mode
Comfort Control

Alarms and Indicators

Wait Indicator
Low Pressure
Indicator
Battery Low Indicator
Power Fail Indicator
In the Reactive (CLP) mode the patient will not
experience the benefits of Active (Alternating) therapy.
Press and hold the Autofirm button for two seconds to
enter Autofirm mode. Once activated, Autofirm creates
a temporary firm surface to allow nursing procedures to
be performed. Autofirm lasts 15 minutes, after which the
pump will default back to the previous setting.
When the pump is in Autofirm mode the Reactive (CLP)
and Comfort Control LEDs are illuminated.
This operation does not function whilst a seat
cushion is connected.
Two buttons control the relative firmness/softness of the
mattress/seat cushion for patient comfort.
The pressure setting is indicated by the green indicator
to the left of the buttons.
The yellow Wait indicator is illuminated when the
mattress/seat is being inflated. The indicator remains
illuminated until the mattress/seat has been fully
inflated.
The red Low Pressure indicator is illuminated whenever
the pump detects low pressure within the mattress/seat.
An audible alarm sounds unless silenced by the Alarm
Mute button.
The indicator will extinguishes once normal pressure is
reached.
See "Troubleshooting" on page 26 for possible
causes of Low Pressure.
The yellow Battery Low indicator will illuminate 2
hours before battery failure.
1 hour before battery failure, the pump will default to
Reactive (CLP) mode, an audible alarm will sound and
the yellow indicator will flash.
The red Power Fail indicator illuminates when a mains
power failure has been detected and no battery backup is
available. An audible alarm sounds until power is
resumed or the pump is switched off using the
Run/Standby button.
If a Power Fail condition arises and no battery is
connected, disconnect the tubeset from the pump. This
13