Controls, Alarms And Indicators; Controls - Arjohuntleigh Auto Logic Instructions For Use Manual

4. Controls, Alarms and Indicators

Controls

Run/Standby
Alarm Mute
Reactive (CLP) Mode
Run/Standby Button
Alarm Mute
Reactive (CLP) Mode
Wait Indicator
Service Indicator
Pressing the Run/Standby button will activate the pump.
The green indicators on the control panel and the front
of the pump will illuminate when the pump is on.
To switch the pump to Standby, the button must be
pressed for two seconds. This prevents accidental
operation.
Unless Transport mode is required, always put the
pump into Standby before disconnecting mattress or
seatpad.
During an alarm condition (except Power Fail Alarm),
the sound of the alarm can be silenced by pressing this
button. The yellow indicator then remains on but the
alarms will be silenced for 15 minutes or until the alarm
condition has been corrected.
Selects the Reactive (Constant Lower Pressure) (CLP),
non-alternating mode. The yellow indicator illuminates
when the pump is in this mode. When the Active
(Alternating) mode (default) is selected, the yellow
indicator will be switched off.
Press the Reactive (CLP) Mode button for
approximately 4 seconds to activate the reactive mode.
The change in the mode will occur at the end of the next
complete alternating cycle, and so a maximum 10
minute delay may be experienced.
12
Low Pressure Indicator
Autofirm
Battery Low Indicator
Power Fail Indicator
Comfort
Controls