Ricoh Priport VT 6000 Service Manual page 57

29 January 1998
No. Display
27 Auto Staple Off
28 Max. Print/Bin
**29 Pht Bckgrnd
Correct
30 Sub Scan Mag.
Adjust
31 MTF Level
32 Image Density
Rank
33 Lead Edge
Margin
34 Line/Pht Mode
Level
34-1 Contrast
34-1-0 Std
(setting for the
Standard tone)
Function
Specifies whether the
staple unit is disabled.
Specifies the
sort/stack number
limit.
Determines whether
the original
background correction
is done in Photo mode.
Adjusts the sub-scan
magnification.
Adjusts the MTF level. 0: Low
In line mode, adjusts
the image density
level.
Adjusts the lead edge
margin.
Use to adjust the
threshold level for
separating line areas
and photo areas in the
Line/Photo mode.
Select the contrast
setting for changing
the threshold for line
and photo.
Adjust the threshold
level to distinguish line
and photo areas for
the Standard tone
setting in the
Line/Photo mode.
There are four
numbers and each
represents the
threshold value for an
image density. Input
the required value for
the one that is blinking,
then press Enter to
move the next one.
4-17
SERVICE PROGRAM MODE
Data Factory
Setting
0: Staple mode
enabled.
1: Staple mode
disabled.
1 to 50 sheets
0: Correction is
not done.
1: Correction is
done.
-1.9 to +1.9%
1: Standard
2: High
3: Maximum
0: Light
1: Standard
2: Dark
4 to 10 mm 5 mm
0: Change the
threshold setting
1: Returns the
setting to default
0: Standard
1: Light
2: Dark
Lt: 0 to 63 Lt: 18
Std: 0 to 63 Std: 16
Dk: 0 to 63 Dk: 22
Dkr: 0 to 63 Dkr: 22
Comments
0
50
0
(0) The factory
setting depends
on the machine.
1
1
0 If "0" is selected
in this mode, the
machine goes to
34-1.
Depending on
the number
selected in this
mode, the
machine goes to
34-1-0, 34-1-2,
or 34-1-3.
If "0" is selected
in 34-1, the
machine goes to
this mode.