Ricoh Priport VT 6000 Service Manual page 49

29 January 1998
Code
E-28 The 1st sorter staple position switch or
staple unit movement switch status
does not change even if the staple unit
shift motor drive signal is applied.
E-29 The 1st transport sort mode position
sensor or the 1st transport non-sort
mode position sensor status does not
change even if the delivery table motor
drive signal is applied.
E-34 The 2nd transport motor rotation sensor
speed is abnormal.
E-36 The 2nd sorter helical wheel H.P.
sensor status does not change even if
the bin shift motor drive signal is
applied.
The bin shift motor rotation sensor
status does not change even if the bin
shift motor drive signal is applied.
E-37 The 2nd sorter jogger bar H.P. sensor
status does not change even if the
jogger bar motor drive signal is applied.
E-38 The 2nd sorter staple position sensor or
staple unit movement sensor status
does not change even if the staple unit
shift motor drive signal is applied.
Problem
4-9
SERVICE TABLES
Possible Causes
1) Defective staple unit shift
motor
2) Defective jogger bar H.P.
sensor
3) Defective staple unit
movement switch
1) Defective 1st transport
sort mode position
sensor
2) Defective 1st transport
non-sort position sensor
3) Defective delivery table
motor
1) Defective 2nd transport
motor
2) Defective 2nd transport
motor rotation sensor
1) Defective bin shift motor
2) Defective helical wheel
H.P. sensor
3) Defective bin shift motor
rotation sensor
1) Defective jogger bar
motor
2) Defective jogger bar H.P.
sensor
1) Defective staple unit shift
motor
2) Defective jogger bar H.P.
sensor
3) Defective staple unit
movement switch