Ricoh Priport VT 6000 Service Manual page 37

INSTALLATION PROCEDURE
18. Install the master roll.
1) Take out the master roll from the plastic bag.
x
NOTE:
x
2) Attach a spool [A] to each end of the
master roll [B].
3) Push the pressure release lever [C] to the
left.
4) Set the master roll in the machine as shown
in the illustration.
5) Remove the tape holding the master roll as
shown to the right.
x
NOTE:
x
6) Insert the leading edge of the master roll
under the platen roller.
7) Return the pressure release lever to the
original position.
8) Plug in the power cord and turn on the main
switch.
9) Press the master cut button.
10) Open the master box cover and remove the
cut strip of master paper.
NOTE: Check that the paper on the master roll is not bent or creased.
11) Close the scanner unit.
Firmly grasp the master roll
since it is very slippery.
Do not remove the strip of
the tape holding the master
roll till step 5 below.
Hold the spools by hand to
remove the tape easier.
It is better to remove the
tape completely, but leave
any parts that remain on the
spools or in the core.
3-10
29 January 1998
C228I500.WMF
[A]
[B]
C228V002-2.WMF
[C]
C228I501.PCX
C228I502.WMF