Connection Example; Figure 4: Gds3710 Back Cover; Figure 5: Rj45 Wires - Grandstream Networks GDS3710 User Manual

Connection Example

In order to connect the GDS either by using PoE or PSU follow steps below:
Open the Back Cover Board of the GDS3710 which should look like following figure.
1. Power the unit using PoE
Cut into the plastic sheath of your RJ45 cable, then Unwind and pair the colors like shown below.
Connect each color of the RJ45 to its associate on the Back Cover of the GDS3710, this way user can
power the unit using PoE.
2. Power the unit using PSU
In order to power the unit using PSU, use a multimeter to detect the polarity of your Power Supply, then
connect GND to negative pole and 12V to positive pole of the PSU.

Figure 4: GDS3710 Back Cover

Figure 5: RJ45 Wires

GDS3710 User Manual
P a g e | 19