Table of Contents
Advertisement
CAUTION
-
Do not use or store this product in a location exposed to high or low temperature that exceeds range
of specification or susceptible to rapid temperature changes.
Example:
-
Do not use this product in extremely humid or dusty locations. It is extremely dangerous to use this
product with its interior penetrated by water or any other fluid or conductive dust. If this product
must be used in such an environment, install it on a dust-proof control panel, for example.
-
Avoid using or storing this product in locations subject to shock or vibration that exceeds range of
specification.
-
Do not use this product in the vicinity of devices that generate strong magnetic force or noise. Such
products will cause this product to malfunction.
-
Do not use or store this product in the presence of chemicals.
-
To clean this product, wipe it gently with a soft cloth dampened with either water or mild detergent.
Do not use chemicals or a volatile solvent, such as benzene or thinner, to prevent pealing or
discoloration of the paint.
-
This product's case may become hot. To avoid being burned, do not touch that section while this
product is in operation or immediately after turning off the power. Avoid installation in a location
where people may come into contact with that section.
-
CONTEC does not provide any guarantee for the integrity of data on Storage medium.
-
Be sure to disconnect the power cable from the outlet before connecting cables to and disconnecting
cables from the connectors and before configuring hardware settings such as switches.
Use grounded and shielded cables to connect to periphery devices.
-
When transporting the product, implement sufficient countermeasures to prevent the
-
product from being directly subjected to vibrations and impacts.
If the battery needs to be replaced, the product will have to be repaired. In this
-
situation, contact your retailer or CONTEC group office.
When disposing of used batteries, do so properly as instructed by the local
-
government.
- Component Life:
(1) Battery---The internal calendar clock and CMOS RAM are backed by a Lithium primary
battery.
The backup time at a temperature of 25°C with the power disconnected is 10 years or
more.
(2) BackLight--- LCD Panel backlight rating life is more than 50,000 hours.
(3) TouchPanel--- The service life is 1 million operations or more.
(4) SD---
* Replacement of expendables is handled as a repair (there will be a charge).
* Component life is not guaranteed value but only referential value.
PT-40 User's manual
- Exposure to direct sun
- In the vicinity of a heat source
* Ambient temperature25°C±2°C, maximum brightness setting, up to
50% of the initial brightness decrease
* Load: 2.45N; speed: 2 times/second; pointed silicone rubber
implement
The SD card is used for the OS storage area. Use an SLC-type SD
card.
1. Introduction
5
Advertisement
Table of Contents
