Ferrite Core - Contec 40 Series User Manual

1. Introduction
About VCCI Class A and EMC Directive Class A secondary conditions
In order to comply with the above standards, attach the included ferrite core to the LAN
cable. To attach the ferrite core, open it, wrap the cable around the core once in a
location that is close to the connector, and then close the ferrite core.
FCC PART 15 Class A Notice
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
6
PT-40 User's manual