Miele FN 3x402 i AU Operating And Installation Instructions page 43

Table of Contents

Advertisement

Problem
The compressor runs
continuously.
The compressor is
switching on more
frequently and for
longer periods.
Possible cause and remedy
This is not a fault. To save energy, the compressor
runs at a lower speed, but for longer, when less
cooling is required.
The ventilation gaps in the housing unit have been
covered or become too dusty.
 Do not block the ventilation gaps.
 Clean the ventilation gaps on a regular basis.
The doors have been opened too frequently, or a
large amount of fresh food has been placed inside
and/or frozen at the same time.
 Only open the door when necessary and for as
short a time as possible.
After a while the temperature will return to normal by
itself.
The door is not properly closed.
A thick layer of ice may have formed in the freezer.
 Close the door.
After a while the temperature will return to normal by
itself.
If a thick layer of ice has formed, it will decrease the
cooling performance and increase the energy
consumption.
 Defrost the appliance and clean it.
The room is too warm. The higher the room
temperature, the longer the compressor has to run.
 See "Installation advice - Location".
The appliance was not properly installed in the niche.
 See "Installation - Building in the appliance".
Problem solving guide
43

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fns 3x402 i au

Table of Contents