Setting the temperature
Use the two sensors underneath the
display to set the temperature.
By touching the sensor
– the temperature will get colder,
– the temperature will get warmer.
While the temperature is being set, the
temperature value will flash.
The following information appears in
the display while the sensors are being
touched:
– When first tapped: The last
temperature selected flashes.
– Each subsequent touch of a sensor:
The temperature is adjusted in 1 °C
steps.
– Leaving a finger on the sensor
changes the temperature
continuously.
Approximately 5 seconds after the last
time a sensor has been touched, the
current temperature inside the
appliance is automatically shown.
or
Touch OK to confirm your selection.
If you have adjusted the temperature,
wait for approx. 6 hours if the
appliance is not very full and for
The correct temperature
approx. 24 hours if the appliance is
full before checking the temperature
display, as it will take this long for the
appliance to give an accurate reading.
If, after this time, the temperature is
still too high or too low, you will need
to adjust it again.
Temperature range
The temperature can be adjusted
between
-15 °C and -28 °C.
21