Table of Contents
Advertisement
109
BDL5585XL LCD
7.6 Resins
RoHS requirements.
WEEE requirements.
PC+ABS
China Rohs required. ( sales in China only)
7.7 Paint Used
RoHS requirements.
WEEE requirements.
7.8 Plastic Mold Tooling
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld
lines, gate marks, ejector marks, etc.).
Painting to cover up cosmetic defects due to molding is strongly discouraged.
No plastic mold tooling
7.9 Plastics Flammability
All Plastics to be Flame Retardant UL 94-V0 or Better (if Display weighs less than 18kg; UL94-V0 is
OK).
Base / Pedestal to be Flame Retardant UL 94-HB.
All major plastic parts (bezel, back cover, base) need to be molded from same resin. Base / Pedestal
otherwise specified.
No plastic parts
7.10 Texture/Glossing of Housing
The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to UN-D249.
The gloss value of texture area < = 20 gloss units.
No plastic parts
7.11 Base Tilt / Swivel Range
Tilt -
Swivel Range -
Base detach -
Tip over -
General Product Specification
N.A. (per commercial spec request)
0°
Should be directly disassembled from main body, so as for easy
install the Display to wall mount.
15° minimum in worst case, base dimension designed so that ID
and tip over requirements can be met.
Advertisement
Table of Contents
