Error Message - Yamaha CDX-E200 Service Manual

ERROR MESSAGE

(1) If stopped by any cause, error message can be displayed by pressing the remote STOP key while pressing and
holding the panel STOP key, or by test mode command number 23.
The player holds the latest error message in EEPROM. So even if stopped with no error, the latest error message
can be displayed with same operation.
(2) Shown below is an example of display. ("E-73" as an example)
(3) Listed in the table below are error messages.
Error Messages List
ERROR MESSAGES
Data cannot be read after finishing search.
E – X 0
E – X 1 Data cannot be read during PLAY(X=0), PAUSE(X=3), or SCAN(X=2).
E – 7 1 At the start, tracking servo is not effective.
At the start, spindle servo PLL is not effective.
E – 7 2
At the start, data can not be read.
E – 7 3
E – 7 5 Tracking servo off in FO balance, or FO fine, or TR fine gain adjustment
and recovery action failure.
Close switch does not work with tray closed.
E – 9 4
E – 9 5 Open switch does not work with tray open.
E – X 7 Traverse(Feed) inner switch does not work.
Recovery action fails after focus drop.
E – X 8
ERROR MN35511 does not give response of SENSE, with resetting by the unit's
microcomputer.
1) Error Code Troubleshooting
X0 , X1 , 73
Error code
YES
Is disc dirty or
scratched?
NO
Outermost TRACKING
Pick-up position
servo defective.
(on mirror
FEED servo defective.
surface)
Within disc range
Pick-up defective, Spindle system
defective (Motor fails to run, etc.)
X7
Error code ............. FEED operation defective.
(Limit switch fails)
Is forced
Feed limit switch
YES
feed operation
defective
available in TEST
Microcomputer defective
mode? Y ...Outward
T ...Inward
NO
FEED servo defective
Microcomputer defective
1 E-73
DESCRIPTION
...... Data cannot be read.
Check by using
another disc.
94 , 95
Error codes ..... Poor tray loading operation.
Does tray
Loading switch detection
YES
operate when
poor Microcomputer
OPEN/CLOSE key is
pressed? defective
NO
Motor defective
Control IC (IC1) defective
Microcomputer defective
X8
Error code ............ Focus drops.
YES
Is disc dirty or
scratched?
NO
TRACKING servo
Outermost
Pick-up position defective.
(on mirror
FEED servo defective.
surface)
Within disc range
FOCUS servo defective
Pick-up defective
CDX-E200
*No. for each state
(meaning of "X")
PLAY X="0"
SCAN X="2"
PAUSE X="3"
PEAK SEARCH X="4"
SEARCH X="5"
START X="7"
STOP X="8"
LOADING X="9"
OPEN X="–"
NO DISC X="C"
Check by using
another disc.
10