Cd Error Message - Yamaha TSX-10 Service Manual

TSX-10/15/20

CD ERROR MESSAGE

(1) If a CD error occurs, an error message can be displayed by selecting " CD TEST MODE 28 Error Msg" and
pressing the "OPEN/CLOSE" key.
(2) Shown below is an example of display. ("E-73" as an example)
(3) Listed in the table below are error messages.
Error Messages List
Error No. Status
E-10 PLAY
E-20 SCAN
E-30 PAUSE
E-70 SEARCH
E-11 PLAY
E-21 SCAN
E-31 PAUSE
E-73 LOAD
E-04 LOAD, SEARCH
E-14 LOAD, SEARCH
E-35
E-06 SEARCH, PLAY, PAUSE
E-47 SEARCH
E-57 STOP
E-77 LOAD, EJECT
E-18 PLAY
E-28 SCAN
E-38 PAUSE
E-48 SEARCH
E-68 LOAD
E-AC
E-AD
MN ERR
1) Error Code Troubleshooting
X0 , X1 , 73
Error code
YES
Is disc dirty or
scratched?
NO
Outermost
Pick-up position
(on mirror
Within disc range
Pick-up defective, Spindle system
defective (Motor fails to run, etc.)
AC , AD
Error codes
Does CD lid
operate when
OPEN/CLOSE key is
pressed?
NO
Motor defective
Control IC (IC405) defective
Microcomputer defective
13
CD fails in the disc data reading after the state shift.
CD fails in the disc data reading.
CD fails in the TOC data reading
Tracking servo is not effective at the DISC MOTOR SERVO PLL.
Disc motor servo PLL is not effective.
CD fails in FOCUS SEARCH.
CD fails in escaping from the LEAD-IN area.
The inner limit switch does not operate at the FEED INNER
CONTROL.
CD fails in recovery from the FOCUS OUT.
Close switch does not operate at the CD Lid CLOSE CONTROL.
Open switch does not operate at the CD Lid OPEN CONTROL.
MN35511 does not give response of SENSE with resetting.
...... Data cannot be read.
Check by using
another disc.
TRACKING
servo defective.
FEED servo defective.
surface)
..... Poor CD lid operation.
Contents
X7
Error code ............. FEED operation defective.
Is forced
YES
feed operation
available in TEST
mode? ...Outward
...Inward
NO
FEED servo defective
Microcomputer defective
X8
Error code ............ Focus drops.
YES
Is disc dirty or
scratched?
NO
Outermost
Pick-up position
(on mirror
surface)
Within disc range
FOCUS servo defective
Pick-up defective
(Limit switch fails)
Feed limit switch
defective
Microcomputer defective
Check by using
another disc.
TRACKING servo
defective.
FEED servo defective.