Other Items Required; Supplies And Tools Needed - GREAT PLANES Super Sportster 90 Instruction Book

Propellers (see engine instructions for size)
3" diameter Spinner
Fuel Tank (14 - 16 oz. or larger)
(Larger tanks require custom fitting)
2 - 3" diameter Main Wheels
1 - 2-3/4" diameter Nose Wheel
(or)
1 - 1-1/4" diameter Tail Wheel
4 - 3/16" Wheel Collars for Main Wheels
2-3 oz. - Thin CA Adhesive
2 oz. - Medium or Thick CA Adhesive
2.5 oz.- 5 Minute Epoxy
2.5 oz.- 30 Minute Epoxy
Hand or Electric Drill
Drill Bits (No. 53. 1/16", 5/64", 3/32" 7/64",
1/8", 5/32", 3/16", 11/64", 13/64", 1/4", 5/16"
Sealing Iron
Heat Gun
Hinge Slotting Tool
Hobby Saw (X-Acto Razor Saw)
X-Acto Knife, #11 Blades
Stab = Stabilizer
Elev = Elevator
LE = Leading Edge (front)
TE = Trailing Edge (rear)
Lt = Left

OTHER ITEMS REQUIRED

SUPPLIES AND TOOLS NEEDED

******************************************************
COMMON ABBREVIATIONS USED IN THIS
BOOK AND ON THE PLANS:
4
2 - 5/32" Wheel Collars for Nose Wheel
(or)
2 - 3/32" Wheel Collars for Tail Wheel
Iron-on Covering Material
Silicone Fuel Tubing
Foam Wing Seating Tape
Foam Rubber Padding, 1/2" thick
Dummy Pilot Figure (2-1/2" - 3" tall)
2 - DuBro E-Z Connectors (or similar)
"Y"-Connector (for double elevator servos)
Pliers
Screw Driver
T-Pins
Straightedge
Masking Tape
Sandpaper, (Coarse, medium and fine grit)
T-Bar sanding block, or similar
Waxed Paper
Balsa Filler
1/4-20 Tap
Tap Wrench
Dremel Moto Tool or similar (Optional)
Rt = Right
" = Inches
Fuse = Fuselage
LG = Landing Gear
Ply = Plywood