Single Supervisor Mode - Cisco Catalyst 4500 series Administration Manual

Chapter 8 Configuring Interfaces

Single Supervisor Mode

In single supervisor mode, WS-X45-SUP-7L-E supports the uplink configuration of at most either two
10-Gigabit or four 1-Gigabit ports
Table 8-1
Supervisor Engine Uplink Ports
A1
Choose 10-Gigabit operation through the command line interface.
SFP+
SFP+
SFP+ and SFP can be inserted in any order for lines 2 to 4.
Redundant Supervisor Mode
In redundant supervisor mode, WS-X45-SUP-7L-E supports 1+1 (in 10-Gigabit mode) and 2+2 (in
1-Gigabit mode)
Table 8-2
Active Supervisor Uplink
Ports
A1
Choose 10-Gigabit operation through the command line interface.
SFP+
SFP+
SFP
SFP
Digital Optical Monitoring Transceiver Support
Command line interface (CLI) commands (show inventory, show idprom interface) are used on
transceivers to obtain serial number, model name, inventory information.
The following commands are specific to the transceivers that support the DOM capability:
•
•
•
OL-30933-01
Uplink Options for Single Supervisor Mode
A2
SFP+
SFP
(Table 8-2).
Uplink Options for Redundant Supervisor Mode
A2 A3 A4
— —
— —
— —
SFP — —
Displays current values and thresholds for all sensor on a particular interface transceiver:
show interfaces int-name transceiver [detail] [threshold]
Enables or disables the entSensorThresholdNotification for all sensors in all the transceivers:
snmp-server enable trap transceiver
Enables or disables transceiver monitoring:
(Table 8-1).
Speeds Achievable with the Following Combination of
Pluggables (Band Width)
20 Gbps
11 Gbps
Standby Supervisor Uplink
Ports
B1 B2 B3 B4
SFP+ — —
SFP — —
SFP+ — —
SFP SFP — —
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
Digital Optical Monitoring Transceiver Support
Speeds Achievable with this
Combination of Pluggables
20 Gbps
11 Gbps
11 Gbps
4 Gbps
8-19