Cisco Catalyst 4500 series Administration Manual page 266

Configuring a VSS
Port security
Ports in the Port-channel:
Index
------+------+------+------------------+-----------
0
1
Time since last port bundled:
Switch#
This example shows how to display a one-line summary per channel group:
Switch# show etherchannel summary
Flags:
Number of channel-groups in use: 3
Number of aggregators:
Group
------+-------------+-----------+-----------------------------------------------
1
10
20
Prior to Cisco Release IOS XE 3.5.0E and IOS 15.2(1)SG, when you tried to add a port to an
EtherChannel from different chassis of the VSS system, an error message displayed:
Switch(config)# int gi2/3/26
Switch(config-if)# no switchport
Switch(config-if)# channel-group 50 mode on
Switch(config-if)#
Switch(config)# int gi1/1/48
Switch(config-if)# no switchport
Switch(config-if)# channel-group 50 mode on
Layer 3 MEC is not supported: GigabitEthernet1/1/48 on switch 1 cannot be part of
port-channel 50 with members on switch 2.
Command rejected: conflicts with Unsupported Layer 3 MEC
Switch(config-if)#
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)SG
5-50
= Disabled
Load Port EC state
00 Gi1/3/26 Desirable-Sl
00 Gi2/2/26 Desirable-Sl
D - down P - bundled in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
U - in use f - failed to allocate aggregator
M - not in use, minimum links not met
u - unsuitable for bundling
w - waiting to be aggregated
d - default port
Port-channel Protocol
Po1(RU) PAgP
Po10(SU) -
Po20(SU) -
Chapter 5
No of bits
0
0
0d:00h:05m:25s Gi2/2/26
3
Ports
Gi1/3/26(P) Gi2/2/26(P)
Te1/1/1(P) Te1/1/4(D)
Te2/1/1(P)
Configuring Virtual Switching Systems
OL-30933-01