Configuring Sso - Cisco Catalyst 4500 series Administration Manual

Configuring NSF with SSO Supervisor Engine Redundancy
•
•
•
•
•
•
•

Configuring SSO

You must configure SSO in order to use NSF with any supported protocol.
To configure SSO, perform this task:
Command
Step 1
Switch(config)# redundancy
Step 2
Switch(config-red)# mode sso
Step 3
Switch(config-red)# end
Step 4
Switch# show running-config
Step 5
Switch# show redundancy states
The sso keyword is supported in Cisco IOS Release 12.2(20)EWA and later releases.
Note
This example shows how to configure the system for SSO and display the redundancy state:
Switch> enable
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# redundancy
Switch(config-red)# mode sso
Switch(config-red)# end
Switch# show redundancy states
my state = 13 -ACTIVE
Redundancy Mode (Operational) = sso
Redundancy Mode (Configured)
Manual Swact = Enabled
Communications = Up
client count = 29
client_notification_TMR = 30000 milliseconds
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
12-10
Verifying BGP NSF, page 12-12
Configuring OSPF NSF, page 12-13
Verifying OSPF NSF, page 12-13
Configuring IS-IS NSF, page 12-14
Verifying IS-IS NSF, page 12-15
Configuring EIGRP NSF, page 12-16
Verifying EIGRP NSF, page 12-16
peer state = 8 -STANDBY HOT
Mode = Duplex
Unit = Primary
Unit ID = 5
Split Mode = Disabled
keep_alive TMR = 9000 milliseconds
keep_alive count = 1
Chapter 12 Configuring Cisco NSF with SSO Supervisor Engine Redundancy
Purpose
Enters redundancy configuration mode.
Configures SSO. When this command is entered, the
redundant supervisor engine is reloaded and begins to
work in SSO mode.
Returns to EXEC mode.
Verifies that SSO is enabled.
Displays the operating redundancy mode.
End with CNTL/Z.
= sso
OL_28731-01