Verifying Redundancy Mode Before Beginning The Issu Process - Cisco Catalyst 4500 series Administration Manual

Chapter 6 Configuring the Cisco IOS In-Service Software Upgrade Process
Command or Action
Step 1
Switch> enable
Step 2
Switch# show issu state [detail]
Step 3
Switch# show redundancy
This example shows how to display the state and the current status of the supervisor engine during the
ISSU process:
Switch> enable
Switch# show issu state
Switch# show redundancy

Verifying Redundancy Mode Before Beginning the ISSU Process

Before you begin the ISSU process, verify the redundancy mode for the system and be sure to configure
NSF and SSO.
The following example displays verification that the system is in SSO mode, that slot 1 is the active
supervisor engine, and that slot 2 is the standby supervisor engine. Both supervisor engines are running
the same Cisco IOS software image.
Switch# show redundancy states
Redundancy Mode (Operational) = Stateful Switchover
Redundancy Mode (Configured)
Redundancy State
Maintenance Mode = Disabled
Communications = Up
client count = 39
client_notification_TMR = 240000 milliseconds
Switch# show redundancy
Redundant System Information :
------------------------------
Switchovers system experienced = 0
OL-30933-01
my state = 13 -ACTIVE
peer state = 8 -STANDBY HOT
Mode = Duplex
Unit = Primary
Unit ID = 1
Manual Swact = enabled
keep_alive TMR = 9000 milliseconds
keep_alive count = 0
keep_alive threshold = 18
RF debug mask = 0x0
Available system uptime = 1 minute
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = Stateful Switchover
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Displays the state of the during the ISSU process.
Displays current or historical status, mode, and related
redundancy information about the device.
= Stateful Switchover
= Stateful Switchover
Software Configuration Guide—Release IOS XE 3.6.0SG and IOS 15.2(2)SG
Performing the ISSU Process
6-19