Specifying The Startup System Image - Cisco Catalyst 4500 series Administration Manual

Modifying the Supervisor Engine Startup Configuration
Darkside Revision 4, Jawa Revision 20, Tatooine Revision 141, Forerunner Revision 1.83
cisco WS-C4503-E (MPC8548) processor (revision 6) with 1048576K bytes of memory.
Processor board ID SPE120301X8
MPC8548 CPU at 1.33GHz, Supervisor 6-E
Last reset from PowerUp
1 Virtual Ethernet interface
52 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Supervisor Engine 7-E, Supervisor Engine 7L-E, and Supervisor Engine 8-E
Switch# show version
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software
(cat4500e-UNIVERSALK9-M), Version 03.03.00.SG5.
CISCO INTERNAL USE ONLY UNIVERSAL DEVELOPMENT K10 IOSD VERSION , synced to V150_5_20_SID
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Wed 14-Dec-11 07:59 by gsbuprod
ROM: 15.0(1r)SG(0.326)
Switch uptime is 7 minutes
System returned to ROM by reload
System image file is
"tftp://172.25.60.31/auto/gsg-sw/interim/flo_gsbu8/newest_image/iosxe/dev/cat4500e-univers
alk9.b
Jawa Revision 7, Snowtrooper Revision 0x0.0x1C
Last reload reason: Reload command
...
License Information for 'WS-X45-SUP7-E'
cisco WS-C4503-E (MPC8572) processor (revision 8) with 2097152K/20480K bytes of memory.
Processor board ID SPE134600QA
MPC8572 CPU at 1.5GHz, Supervisor 7
Last reset from Reload
1 Virtual Ethernet interface
96 Gigabit Ethernet interfaces
4 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Configuration register is 0x40

Specifying the Startup System Image

You can enter multiple boot commands in the startup configuration file or in the BOOT environment
variable to provide backup methods for loading a system image.
The BOOT environment variable is also described in the "Specify the Startup System Image in the
Configuration File" section in the "Loading and Maintaining System Images and Microcode" chapter of
the Cisco IOS Configuration Fundamentals Configuration Guide.
Use the following sections to configure your switch to boot from flash memory. Flash memory can be
either single in-line memory modules (SIMMs) or flash disks. Check the appropriate hardware
installation and maintenance guide for information about types of flash memory.
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
3-30
License Level: entservices
Next reboot license Level: entservices
Chapter 3
Type: Permanent
Configuring the Switch for the First Time
OL-30933-01