Command-Line Interfaces
This chapter describes the CLIs you use to configure the Catalyst 4500 series switch. This chapter
includes the following major sections:
Accessing the Switch CLI, page 2-2
•
Performing Command-Line Processing, page 2-3
•
Performing History Substitution, page 2-4
•
About Cisco IOS Command Modes, page 2-4
•
Getting a List of Commands and Syntax, page 2-5
•
•
ROMMON Command-Line Interface, page 2-7
•
Archiving Crashfiles Information, page 2-8
•
Displaying a Crash Dump for Supervisor Engine 6-E and 6L-E, page 2-8
For complete syntax and usage information for the switch commands used in this chapter, see the Cisco
Note
Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If a command is not in the Catalyst 4500 Series Switch Command Reference, you can locate it in the
Cisco IOS library. See the Cisco IOS Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/ps6350/index.html
The following command changes apply only to Supervisor Engines 6-E and 6L-E:
The rename command is supported in the FAT file system for bootflash and slot0.
•
•
The fsck command is supported for the slot0 device. It is not supported in the file systems on
supervisor engines other than Supervisor Engine 6-E and 6L-E.
The following additional file management commands are supported on Supervisor Engine 7-E,
Supervisor Engine 7L-E, and Supervisor Engine 8-E:
verify <filename>
•
delete <filename>
•
copy <source_flename>, target_filename>
•
OL-30933-01
C H A P T E R
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
2
2-1