Configuring Static Routing Support - Cisco Catalyst 4500 series Administration Manual

Configuring Enhanced Object Tracking Features

Configuring Static Routing Support

Static routing support using enhanced object tracking provides the ability for the switch to use ICMP
pings to identify when a preconfigured static route or a DHCP route goes down. When tracking is
enabled, the system tracks the state of the route and informs the client when that state changes. Static
route object tracking uses Cisco IP SLAs to generate ICMP pings to monitor the state of the connection
to the primary gateway.
For more information about Cisco IP SLAs support on the switch, see
IOS IP SLA Operations."
•
You use this process to configure static route object tracking:
Configure a primary interface for static routing or for DHCP.ex
Step 1
Configure an IP SLAs agent to ping an IP address using a primary interface and a track object to monitor
Step 2
the state of the agent.
Configure a default static default route using a secondary interface. This route is used only if the primary
Step 3
route is removed.
Configuring a Primary Interface
To configure a primary interface for static routing, perform this task:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
description string
Step 4
ip address ip-address mask [secondary]
Step 5
exit
To configure a primary interface for DHCP, perform this task:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
description string
Step 4
ip dhcp client route track number
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
60-10
For more information about static route object tracking, see:
http://www.cisco.com/en/US/docs/ios/dial/configuration/guide/dia_rel_stc_rtg_bckup_support_TS
D_Island_of_Content_Chapter.html
Purpose
Enters global configuration mode.
Selects a primary or secondary interface and enter interface
configuration mode.
Adds a description to the interface.
Sets the primary or secondary IP address for the interface.
Returns to global configuration mode.
Purpose
Enters global configuration mode.
Selects a primary or secondary interface and enter interface
configuration mode.
Adds a description to the interface.
Configures the DCHP client to associate any added routes with the
specified track number. Valid numbers are from 1 to 500.
Chapter 60 Configuring Enhanced Object Tracking
Chapter 69, "Configuring Cisco
OL_28731-01