Cisco Catalyst 4500 series Administration Manual page 1219

Chapter 46 Configuring 802.1X Port-Based Authentication
Switch(config)# exit
To determine if a host was authenticated using 802.1X when fallback authentication is configured on the
port, enter the following commands:
Switch# show authentication sessions interface g7/2
Common Session ID:
Runnable methods list:
Switch# show dot1x interfaces g7/2 detail
Dot1x Info for GigabitEthernet7/2
-----------------------------------
PAE
PortControl
ControlDirection
HostMode
QuietPeriod
ServerTimeout
SuppTimeout
ReAuthMax
MaxReq
TxPeriod
Dot1x Authenticator Client List
-------------------------------
Supplicant
Session ID
Auth SM State
Auth BEND SM State
Port Status
To determine if a host was authenticated using MAB when fallback authentication is configured on the
port, enter the following commands:
Switch# show authentication sessions interface g7/2
OL_28731-01
Interface: GigabitEthernet7/2
MAC Address: 0060.b057.4687
IP Address: Unknown
User-Name: test2
Status: Authz Success
Domain: DATA
Oper host mode: multi-auth
Oper control dir: both
Authorized By: Authentication Server
Vlan Policy: N/A
Session timeout: N/A
Idle timeout: N/A
C0A8013F0000000901BAB560
Acct Session ID: 0x0000000B
Handle: 0xE8000009
Method State
dot1x Authc Success
mab Not run
= AUTHENTICATOR
= AUTO
= Both
= MULTI_AUTH
= 60
= 0
= 30
= 2
= 2
= 2
= 0060.b057.4687
= C0A8013F0000000901BAB560
= AUTHENTICATED
= IDLE
= AUTHORIZED
Interface: GigabitEthernet7/2
MAC Address: 0060.b057.4687
IP Address: 192.168.22.22
User-Name: 0060b0574687
Status: Authz Success
Domain: DATA
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
Configuring 802.1X Port-Based Authentication
46-81