Coa Request Commands - Cisco Catalyst 4500 series Administration Manual

Hide thumbs Also See for Catalyst 4500 series:
Table of Contents

Advertisement

Chapter 46
Configuring 802.1X Port-Based Authentication
Session Identification
For disconnect and CoA requests targeted at a particular session, the switch locates the session based on
one or more of the following attributes:
Unless all session identification attributes included in the CoA message match the session, the switch
returns a Disconnect-NAK or CoA-NAK with the "Invalid Attribute Value" error-code attribute.
The packet format for a CoA Request code as defined in RFC 5176 consists of the fields: Code,
Identifier, Length, Authenticator, and Attributes in Type:Length:Value (TLV) format.
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
|
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
|
|
|
|
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
|
+-+-+-+-+-+-+-+-+-+-+-+-+-
The attributes field is used to carry Cisco VSAs.
CoA ACK Response Code
If the authorization state is changed successfully, a positive acknowledgement (ACK) is sent. The
attributes returned within CoA ACK will vary based on the CoA Request and are discussed in individual
CoA Commands.
CoA NAK Response Code
A negative acknowledgement (NAK) indicates a failure to change the authorization state and can include
attributes that indicate the reason for the failure. Use show commands to verify a successful CoA.

CoA Request Commands

This section includes:
The switch supports the commands shown in
OL_28731-01
Calling-Station-Id (IETF attribute #31 which contains the host MAC address)
Audit-Session-Id (Cisco VSA)
Acct-Session-Id (IETF attribute #44)
0
1
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
Code
|
Identifier
Attributes ...
Session Reauthentication
Session Termination
CoA Disconnect-Request
CoA Request: Disable Host Port
CoA Request: Bounce-Port
2
|
Length
Authenticator
Table
46-4.
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
Controlling Switch Access with RADIUS
3
|
|
|
|
|
46-101

Advertisement

Table of Contents
loading

Table of Contents