Configuring Pvlans - Cisco Catalyst 4500 series Administration Manual

Chapter 44 Configuring Private VLANs
Command
show interface private-vlan mapping
switchport mode private-vlan {host |
promiscuous | trunk promiscuous |
trunk [secondary]}
switchport private-vlan mapping
[trunk] primary_vlan_ID
{secondary_vlan_list | add
secondary_vlan_list | remove
secondary_vlan_list}
Switch(config-if)# switchport
private-vlan host-association
primary_vlan_ID secondary_vlan_ID
switchport private-vlan association
trunk primary_vlan_ID
secondary_vlan_ID
switchport private-vlan trunk allowed
vlan vlan_list all | none | [add | remove
| except] vlan_atom[,vlan_atom...]
switchport private-vlan trunk native
vlan vlan_id

Configuring PVLANs

These sections describe how to configure PVLANs:
•
•
•
•
•
•
•
OL_28731-01
Purpose
Verifies the configuration.
Configures a Layer 2 interface as a
PVLAN port.
Maps the PVLAN promiscuous port
to a primary VLAN and to selected
secondary VLANs.
Associates the Layer 2 interface with
a PVLAN.
You can associate only one
Note
primary-secondary VLAN
pair to the isolated port.
Configures association between
primary VLANs and secondary
VLANs the PVLAN trunk port with a
PVLAN.
You can configure the
Note
isolated trunk port with
multiple primary-secondary
pair.
Configures a list of allowed normal
VLANs on a PVLAN trunk port.
Configures a VLAN to which
untagged packets (as in IEEE 802.1Q
tagging) are assigned on a PVLAN
trunk port.
Basic PVLAN Configuration Procedure, page 44-12
Default Private-VLAN Configuration, page 44-12
PVLAN Configuration Guidelines and Restrictions, page 44-12
Configuring a VLAN as a PVLAN, page 44-15
Associating a Secondary VLAN with a Primary VLAN, page 44-16
Configuring a Layer 2 Interface as a PVLAN Promiscuous Port, page 44-17
Configuring a Layer 2 Interface as a PVLAN Host Port, page 44-18
Location
Permitting Routing of Secondary
VLAN Ingress Traffic, page 44-23
Configuring PVLANs, page 44-11
Configuring a Layer 2 Interface as a
PVLAN Promiscuous Port,
page 44-17
Configuring a Layer 2 Interface as a
Promiscuous PVLAN Trunk Port,
page 44-21
Configuring a Layer 2 Interface as a
PVLAN Host Port, page 44-18
Configuring a Layer 2 Interface as an
Isolated PVLAN Trunk Port,
page 44-19
Configuring a Layer 2 Interface as an
Isolated PVLAN Trunk Port,
page 44-19
Configuring a Layer 2 Interface as an
Isolated PVLAN Trunk Port,
page 44-19
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
Configuring PVLANs
44-11