Cisco Catalyst 4500 series Administration Manual page 1312

Configuring Port Security on Trunk Ports
Figure 49-2 Trunk Port Security
Logical representation of switch
Access port in VLAN 2
You can configure various port security related parameters on a per-port per-VLAN basis.
Note The steps involved in configuring port security parameters is similar to those for access ports. In addition
to those steps, the following per-port per-VLAN configuration steps are supported for trunk ports.
To configure port security related parameters on a per-VLAN per-port basis, perform this task:
Command
Step 1
Switch(config)# interface interface_id
interface port-channel port_channel_number
Step 2
Switch(config-if)# switchport trunk encapsulation
dot1q
Step 3
Switch(config-if)# switchport mode trunk
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
49-18
SVI 2
5/1 5/2
SV1 3
5/3
gi1/1
ISL or
dot1q trunk
Metro
Layer 2 switch
Access port in VLAN 3
Purpose
Enters interface configuration mode and specifies the
interface to configure.
The interface can be a Layer 2 port channel
Note
logical interface.
Sets the trunk encapsulation format to 802.1Q.
Sets the interface mode.
Note An interface in the default mode (dynamic auto)
cannot be configured as a secure port.
Chapter 49 Configuring Port Security
5/4
OL_28731-01