Projecting An Image (Basic Operation); Turning On The Projector - NEC NP3150 User Manual

3. Projecting an Image (Basic Operation)

Turning on the Projector

NOTE:
• The projector has two power switches: a main power switch and a POWER (ON/STAND BY) button (POWER ON and OFF on the
remote control).
• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off ( ) po-
sition. Failure to do so may cause damage to the projector.
• The projector has a feature to prevent itself from being used by unauthorized individuals. To use this feature, register a key-
word. ( page 45)
1. Remove the lens cap.
2. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
POWER
3. After making sure that the projector is in standby
mode, press the POWER (ON/STAND BY) or POWER
(ON) button for a minimum of 2 seconds when the
STATUS indicator goes off and the POWER indicator
starts blinking.
When the POWER indicator turns a steady green,
and the projector is ready to use.
NOTE: When no signal is available, a blue, black or logo screen is displayed.
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
W
3D REFORM AUTO ADJUST
P
POWER
23
USB
LAMP
STATUS
POWER
S-VIDEO
USB
LAMP
STATUS
POWER
SOURCE ON/STAND BY
P
POWER
O
P
POWER POWER
OFF ON
COMPUTER
1 2
VIDEO VIEWER
COMPONENT
3
NETWORK
SELECT
P O
P
POWER