Adjusting the Tilt Foot
1. Lift the front edge of the projector.
CAUTION:
2. Push up the Adjustable Tilt Foot Levers on the right and left sides
of the projector to extend the adjustable tilt feet (maximum height).
3. Lower the front of the projector to the desired height.
4. Release the Adjustable Tilt Foot lever to lock the Adjustable tilt foot.
There is approximately 10 degrees (up) of adjustment for the front of
the projector.
TIP: For operating the [KEYSTONE] screen, see "
tortion" on page 30.
NOTE: Your "Keystone" correction data can be reset by pressing and holding
the 3D REFORM button for a minimum of 2 seconds.
CAUTION:
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
3. Projecting an Image (Basic Operation)
Adjustable Tilt
Foot Lever
Adjustable Tilt Foot
Correcting Keystone Dis-
4
29
1
2
2
Adjustable Tilt
Foot Lever
3
4